Single twister content analysis of operating instructions and precautions
Single twister job content
1、turn on the power switch、check whether single twister machine in a normal boot state.
2、according to the blueprint specifications are correct on-line confirmation .
3、pull the wire from the guide pulley Tension had to die mouth twisted eye、stripped outside is PVC, stranded wire and then connect the lead wire is pulled through the eye pattern rubber traction to the shaft .
4、according to the blueprint set twisted away、twisted to、for tension、including belt tension and other parameters.
5、according to the order requirements and set the total number of stranded meters down a few meters ahead .
6、start the machine . Check that the rear of the first seizure of qualified energy production .
7、the normal operation of the machine、and do self- examination.
8、when the lower shaft、the twisted wire with a good cleaning film wrap, label、into designated locations.
9、when the package of aluminum foil、according to the blueprint to select the appropriate size and twist to a unified direction packed in bag with Handicap, and adjust the tension after proper surface contact with a conductive foil core cable.
10 foil package with the governor to be stranded with wire speed to maintain a balance .
Single twister job Precautions
1、single twister during normal operation、is strictly prohibited lid open .
2, can not do the deadlock when wiring. ( With cotton thread socket、attention socket direction )
3, the lower shaft To knot knot meter number and the number indicated on the label、so that the next process operation.
4、non-emergency stop, can not press the red emergency stop button.
5、after the shutdown off the power .
6、when the foil bag to completely wrap the core wire、aluminum foil, an aluminum foil is usually 27% -30 % overlap、the overlapping width is 2-4mm ( specific reference model of the specific requirements of the line card charge ) .
7、foil tension to the right, the tension is too large foil easily broken、the tension is too tight wire and packet does not slip .
8、can not wrap foil anti- conductive surface ( glossy white、with a multimeter test for conduction ) must wrap the core wire and the ground .
9、can not be wrapped in the middle ground wire should be wound on the side of the entire core of aluminum foil in contact with a conductive surface .
10、the production of abnormal、not their own to solve, immediately stop and report processing foreman or technician .
Note that size can not be too tight when stranded wire through the 11、single twister installed line eye pattern . Wire to prevent scratching .
12、tension adjustment should be appropriate ( too tight when ) will cause the lower outer core is intact inside the state line stretched .